Allied Telesis AT-S62 - Manual (Page 723)

AT-S62 User’s Guide
Section VIII: Web Browser Management 723
This level provides the greatest level of security. You can select
this value if you configured the Security Model parameter with
the SNMPv3 protocol.
10. In the Storage Type parameter, select one of the following storage
types for this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Parameters Table to the configuration file.
After making changes to a Target Parameters Table entry with a
Volatile storage type, then Save Changes does not appear on the
Configuration Tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the Target Parameters Table to the configuration file. After
making changes to a Target Parameters Table entry with a
NonVolatile storage type, then Save Changes appears on the
Configuration Tab.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Target Parameters Table
entry takes effect immediately.
11. Click Apply to update the SNMPv3 Target Parameters Table.
12. To save your changes, return to the General Tab and click Save
Changes.
Deleting a
Target
Parameters
Table Entry
To delete an SNMPv3 Target Parameters Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 251
on page 720.
4. Click the circle next to the Target Parameters Table entry that you
want to delete. Then click Remove.