Allied Telesis AT-S62 - Manual (Page 809)

AT-S62 User’s Guide
Section VIII: Web Browser Management 809
Configuring RADIUS and TACACS+
To configure the authentication protocols, perform the following
procedure:
1. From the Home Page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 296.
Figure 296 Server-based Authentication Tab (Configuration)
Note
The Enable Server-based Authentication check box applies only to
new manager accounts, described in TACACS+ and RADIUS
Overview on page 553. It does not apply to 802.1x port-based access
control, described in 802.1x Port-based Access Control Overview on
page 464.
3. To select an authentication protocol, click either RADIUS or TACACS+
in the Authentication Method section of the tab. The default is
TACACS+.
Note
The switch can support only one authentication protocol at a time.
Additionally, you cannot select a different authenticator protocol
when this feature is enabled.