Allied Telesis AT-S62 - Manual (Page 80)

Chapter 4: Basic Switch Parameters
Section I: Basic Operations 80
Setting the Switch’s Temperature Threshold
You can set a temperature threshold on the switch which, if exceeded,
causes the unit to send an SNMP trap to your management workstation.
The default threshold is 90
° Celsius.
To change the temperature threshold for the switch, do the following:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 2 to select System
Configuration.
3. From the System Configuration menu, type 9 to select Configure
System Hardware.
The Configure System Hardware menu is shown in Figure 15.
Figure 15 Configure System Hardware Menu
The menu displays the current temperature threshold for the
switch.
4. Type 1 to select Temperature Threshold and, when prompted, enter
a new threshold value. The range is -25 ° to 90° Celsius.
5. After making the change, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Configure System Hardware
1 - Temperature Threshold (Celsius) .......... 90 C
R - Return to Previous Menu
Enter your selection?