Allied Telesis AT-S62 - Manual (Page 700)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 700
NonVolatile
Select this storage type if you want the ability to save an entry in
the Access Table to the configuration file. After making changes
to an Access Table entry with a NonVolatile storage type, Save
Changes appears on the General Tab.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Access Table entry will take
effect immediately.
12. Click Apply to update the SNMPv3 Access Table.
13. To save your changes, return to the General Tab and click Save
Changes.
Deleting an
Access Table
Entry
To delete an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 239 on page
697.
4. Display the Access Table entry that you want to delete.
Click Next or Previous to display an entry.
5. Click Remove.
A warning message is displayed. Click OK to remove the Access
Table entry.
6. To save your changes, return to the General Tab and click Save
Changes.