Allied Telesis AT-S62 - Manual (Page 540)

Chapter 27: Public Key Infrastructure Certificates
Section VII: Management Security 540
Installing CA Certificates onto a Switch
This section lists the procedures to installing a certificate created by a
public or private CA onto the switch. It should be noted that a CA
generated certificate will consist of several certificates, with a minimum
of two. All the certificates from the CA must be installed on the switch.
Note
A certificate from a CA can only be used on the switch where you
created the encryption key pair and enrollment request. Do not
install the certificate on any other switch.
To install CA certificates on a switch, perform the following procedure:
1. Download the certificates from your management workstation or FTP
server to the AT-S62 file system on the switch. For instructions, refer
to Downloading a System File on page 171.
2. Load the certificates into the certificate database. For instructions,
refer to Adding a Certificate to the Database on page 528.
3. Activate HTTPS on the switch by configuring the web server and
specifying the key pair used to create the enrollment request as the
active key pair. For instructions, refer to Configuring the Web Server
on page 490.