Allied Telesis AT-S62 - Manual (Page 259)

AT-S62 User’s Guide
Section III: SNMPv3 Operations 259
Modifying an
SNMPv3 Access
Table Entry
This section describes how to modify parameters in an SNMPv3 Access
Table entry. For each entry in the SNMPv3 Access Table, you can modify
the following parameters:
❑ Read View Name
❑ Write View Name
❑ Notify View Name
❑ Storage Type
Configure the values of the Read View Name, Write View Name, and
Notify View Name parameters with values previously configured with
the View Name parameter in the SNMPv3 View Table. This is the only
way to associate a Group Name with these Views. See Creating an
SNMPv3 View Table Entry on page 244.
See the following procedures:
❑ Modifying the Read View Name on page 259
❑ Modifying the Write View Name on page 262
❑ Modifying the Notify View Name on page 264
❑ Modifying the Storage Type on page 266
Modifying the Read View Name
To modify the Read View Name parameter in an SNMPv3 Access Table
entry, perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 4 to select Configure
SNMPv3 Access Table.
The Configure SNMPv3 Access Table is shown in Figure 76 on
page 254.
3. From the Configure SNMPv3 Access Table, type 3 to select Modify
SNMPv3 Table Entry.