Allied Telesis AT-S62 - Manual (Page 432)

Chapter 21: GARP VLAN Registration Protocol
Section V: Virtual LANs 432
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This will
protect against unauthorized access to restricted areas of your
network. For further information, refer to GVRP and Network
Security on page 424.
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 125 on page
400.
2. From the VLAN Configuration menu, type 8 to select Configure GARP-
GVRP.
The GARP-GVRP menu is shown in Figure 137 on page 430.
3. Type P - GVRP Port Parameters to configure the switch ports.
The GVRP Port Parameters Menu is shown in Figure 138.
Figure 138 GVRP Port Parameters Menu
4. Type 1 to configure GVRP Port Settings.
The following prompt is displayed:
Enter port-list:
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
GVRP Port Parameters
1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration
R - Return to Previous Menu
Enter your selection?