Allied Telesis AT-S62 - Manual (Page 688)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 688
6. In the Authentication Password field, enter an authentication
password of up to 32 alphanumeric characters.
7. In the Confirm Authentication Password field, re-enter the
authentication password.
Note
If you have the AT-S60 software version 2.1.0 that does not contain
the encryption features, then the Privacy Protocol field is read-only
field and it is set to None.
Note
You can only configure the Privacy Protocol if you have configured
the Authentication Protocol with the MD5 or SHA values.
8. In the Privacy Protocol field, enter one of the following options:
DES
Select this value to make the DES privacy (or encryption) protocol
the privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are
encrypted with the DES protocol.
None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between
the host and the switch are not encrypted.
9. In the Privacy Password field, enter a privacy password of up to 32
alphanumeric characters.
10. In the Confirm Privacy Password field, re-enter the privacy password.
11. In the Storage Type field, enter one of the following storage options
for this User Table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 User Table to the configuration file. After
making changes to an SNMPv3 User Table entry with a Volatile
storage type, Save Changes does not appear on the General Tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 User Table to the configuration file. After making
changes to an SNMPv3 User Table entry with a NonVolatile
storage type, Save Changes appears on the General Tab.