Allied Telesis AT-S62 - Manual (Page 703)

AT-S62 User’s Guide
Section VIII: Web Browser Management 703
Configuring the SNMPv3 SecurityToGroup Table
You can create, delete, and modify an SNMPv3 SecurityToGroup Table
entry. See the following procedures:
❑ Creating a SecurityToGroup Table Entry on page 703
❑ Deleting a SecurityToGroup Table Entry on page 705
❑ Modifying a SecurityToGroup Table Entry on page 706
For reference information about the SNMPv3Configuring the SNMPv3
SecurityToGroup Table on page 703.
Creating a
SecurityToGroup
Table Entry
To create an entry in the SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 242.
Figure 242 SNMPv3 SecurityToGroup Table Page