Allied Telesis AT-S62 - Manual (Page 740)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 740
Displaying
Target
Parameters
Table Entries
To display entries in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Monitoring.
The Monitoring System Page is displayed with the General Tab
selected by default, as shown in Figure 195 on page 590.
2. Select the SNMP Tab.
3. From the SNMP Monitoring Tab, click the circle next to the View
Target Parameters Table.
4. Click View at the bottom of the page.
The Monitoring, SNMPv3 Target Parameters Table Page is shown
in Figure 262.
Figure 263 Monitoring, SNMPv3 Target Parameters Table Page