Allied Telesis AT-S62 - Manual (Page 711)

AT-S62 User’s Guide
Section VIII: Web Browser Management 711
Modifying a
Notify Table
Entry
To modify an entry in the SNMPv3 Notify Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Notify Table. Then click Configure at the bottom of the page.
The SNMPv3 Notify Table Page is shown in Figure 245 on page
708.
4. Click the circle next to the table entry that you want to change. Then
click Modify.
The Modify SNMPv3 Notify Page is shown in Figure 247
Figure 247 Modify SNMPv3 Notify Page
5. In the Notify Tag field, enter a description name of the Notify Tag.
Enter a name of up to 32 alphanumeric characters.
6. In the Notify Type field, enter one of the following message types:
Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expects a response from the host.
Inform
Indicates this notify table is used to send inform messages. With
this message type, the switch expects a response from the host.