Allied Telesis AT-S62 - Manual (Page 730)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 730
making changes to an SNMPv3 Community Table entry with a
NonVolatile storage type, Save Changes appears on the General
Tab.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Community Table entry
takes effect immediately.
10. Click Apply to update the SNMPv3 Community Table.
11. To save your changes, return to the General Tab and click Save
Changes.
Deleting an
SNMPv3
Community
Table Entry
To delete an entry in the SNMPv3 Community Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 254 on
page 728.
4. Click the circle next to the SNMPv3 Community Table entry that you
want to delete. Then click Remove.
A warning message is displayed. Click OK to remove the SNMPv3
Community Table entry.
5. To save your changes, return to the General Tab and click Save
Changes.