Allied Telesis AT-S62 - Manual (Page 431)

AT-S62 User’s Guide
Section V: Virtual LANs 431
6. Choose one of the following:
E to enable GIP.
D to disable GIP.
Note
Do not disable GIP if you intend to use GVRP. GIP is required to
propagate VLAN information among the ports of the switch.
Caution
The following steps change the three GVRP timers. The settings for
these timers must be the same on all GVRP-active devices in your
network.
7. Type 3 - GVRP Join Timer to change the value of the Join Timer.
The following prompt is displayed:
Enter new value (in centi seconds): [10 to 60] -> 20
8. Enter a new value for the Join Timer field in centi seconds which are
one hundredths of a second. The default is 20 centiseconds.
If you change this field, it must in relation to the GVRP Leave Timer
according to the following equation:
Join Timer <= (2 x (GVRP Leave Timer))
9. Type 4 - GVRP Leave Timer to enter a new value for this field.
The following prompt is displayed:
Enter new value (in centi seconds): [30 to 180] -> 60
10. Type 5 - GVRP Leave All Timer to enter a new value for this field. The
default is 60 centiseconds.
The following prompt is displayed:
Enter new value (in centi seconds): [500 to 3000] -
> 1000
11. Enter a value in centiseconds. The default is 1000 centiseconds.