Allied Telesis AT-S62 - Manual (Page 308)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 308
2. From the Configure SNMPv3 Table Menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table Menu is shown in
Figure 84.
3. From the Configure SNMPv3 Target Parameters Table Menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table Menu is shown in
Figure 85 on page 303.
4. To modify the Storage Type, type 5 to select Storage Type.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32-alphanumeric characters.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 Target Parameters Table to the configuration
file. After making changes to an SNMPv3 Target Parameters Table
entry with a Volatile storage type, the S - Save Configuration
Changes option does not appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 Target Parameters Table to the configuration file.
After making changes to an SNMPv3 Target Parameters Table
entry with a NonVolatile storage type, the S - Save Configuration
Changes option appears on the Main Menu, allowing you to save
your changes.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.