Allied Telesis AT-S62 - Manual (Page 548)

Chapter 28: Secure Shell (SSH) Protocol
Section VII: Management Security 548
Configuring the SSH Server
This section describes how to configure the SSH server software on the
switch. For a description of all the steps required to configure an SSH
server, see General Steps to Configuring SSH on page 547.
This procedure assumes that you have already created the two key pairs.
If you have not created the keys, go to Creating an Encryption Key on
page 500.
While you are configuring the SSH feature, you must disable the SSH
server. When you have completed your configuration changes, enable
the SSH server to permit SSH client connections.
Note
Allied Telesyn recommends disabling the Telnet server before
activating SSH. Otherwise, the security functions provided by SSH
are lost. See Enabling or Disabling the Telnet Server on page 73.
To configure the SSH server software on the switch, perform the
following procedure:
1. From the Main Menu, type 7 to select Security and Services.
2. From the Security and Services menu, type 5 to select Secure Shell
(SSH).
The Secure Shell (SSH) Menu is shown in Figure 179.
Figure 179 Secure Shell (SSH) Menu
Allied Telesyn Ethernet Switch - AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Secure Shell (SSH)
1 - SSH Server Status ....... Disabled
2 - Host Key ID..............
3 - Server Key ID ...........
4 - Server Key Expiry Time .. 0 hours
5 - Login Timeout ........... 180 seconds
6 - Show Server Information
R - Return to Previous Menu
Enter your selection?