Allied Telesis AT-S62 - Manual (Page 683)

AT-S62 User’s Guide
Section VIII: Web Browser Management 683
Configuring the SNMPv3 User Table
You can create, delete, and modify an SNMPv3 User Table entry. See the
following procedures:
❑ Creating a User Table Entry on page 683
❑ Deleting a User Table Entry on page 686
❑ Modifying a User Table Entry on page 686
For reference information about the SNMPv3 User Table, see
Configuring the SNMPv3 User Table on page 234.
Creating a User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
User Table. Then click Configure at the bottom of the page.
The SNMPv3 User Table Page is shown in Figure 233.
Figure 233 SNMPv3 User Table Page