Allied Telesis AT-S62 - Manual (Page 307)

AT-S62 User’s Guide
Section III: SNMPv3 Operations 307
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table Menu is shown in
Figure 84.
3. From the Configure SNMPv3 Target Parameters Table Menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table Menu is shown in
Figure 85 on page 303.
4. To modify the Message Process Model, type 4 to select Set Message
Processing Model.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32-alphanumeric characters.
The following prompt is displayed:
Enter Message Processing Model[1-v1,2-v2c,3-v3]:
6. Select one of the following SNMP protocols that is used to process, or
send messages:
1-v1
Select this value to process messages with the SNMPv1 protocol.
2-v2c
Select this value to process messages with the Security Name, or
User Name, with the SNMPv2c protocol.
3-v3
Select this value to process messages with the SNMPv3 protocol.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Storage Type
To modify the Storage Type parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.