Allied Telesis AT-S62 - Manual (Page 405)

AT-S62 User’s Guide
Section V: Virtual LANs 405
Example of Creating a Tagged VLAN
The following procedure creates the Engineering VLAN in the top switch
illustrated in Tagged VLAN Example on page 398. This VLAN will be
assigned a VID of 3. It will consist of four untagged ports, Ports 9, 10, 11,
and 20, and two untagged ports, Ports 8 and 16.
To create the example Engineering VLAN, perform the following
procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 125 on page 400.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 126 on page 401.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 127 on page 401.
4. Type 1 to select VLAN Name and enter “Engineering”.
5. Type 2 to select VLAN ID (VID) and enter “3”. This is the VID value for
the new VLAN.
6. Type 3 to select Tagged Ports and enter “8,16”. These are the tagged
ports of the VLAN on the switch.
7. Type 4 to select Untagged Ports and enter “9-11, 20”. These are the
untagged ports of the VLAN.
8. Type C to select Create VLAN.
9. After the switch displays the prompt notifying you that it created the
VLAN, press any key.
The new Engineering VLAN has now been created.
10. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.