Allied Telesis AT-S62 - Manual (Page 156)

Chapter 11: File System
Section II: Advanced Operations 156
Copying, Renaming, and Deleting System Files
Use this procedure to copy, rename, and delete system files. To view a
list of system file names, see Displaying System Files on page 158.
Note
Files with the extension UKF are encryption key pairs. These files
cannot be copied, renamed, or deleted from the file system. To
delete a key pair from the switch, refer to Deleting an Encryption Key
on page 504.
To copy, rename, or delete a file in the file system, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 9 to select System
Utilities.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 41 on page 150.
4. To copy a file, do the following:
a. From the File Menu, type 4 to select Copy File.
Note
Selecting Copy File does not allow you to overwrite files.
The following prompt is displayed:
Enter the source file name:
b. Enter the name of the file you want to copy.
The following prompt is displayed:
Enter the destination file name:
c. Enter the new file name.
You can enter a file name of up to 16 alphanumeric characters,
followed by a 3 letter extension. You should keep the same
extension as the original filename.
The following message is displayed:
Please wait...
Press any key ...
d. Press any key to return to the File Operations menu.