Allied Telesis AT-S62 - Manual (Page 291)

AT-S62 User’s Guide
Section III: SNMPv3 Operations 291
6. Enter a timeout value in milliseconds.
When an Inform message is generated, it requires a response from
the switch. The timeout value determines how long the switch
considers the Inform message an active message. This parameter
applies to Inform messages only. The range is from 0 to
2,147,483,647 milliseconds. The default value is 1500
milliseconds.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Target Address Retries
The Target Address Retries parameter only applies when the message
type is an Inform message. To modify the Target Address Retries
parameter in an SNMPv3 Target Address Table entry, perform the
following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table Menu is shown in
Figure 82 on page 284.
3. From the Configure SNMPv3 Target Address Table Menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table Menu is shown in
Figure 83 on page 288.
4. To modify the Target Address Retries, type 4 to select Set Target
Address Retries.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32-
alphanumeric characters.
The following prompt is displayed:
Enter Retries:[0 to 255]-> 3