Allied Telesis AT-S62 - Manual (Page 319)

AT-S62 User’s Guide
Section III: SNMPv3 Operations 319
Displaying SNMPv3 Table Menus
The procedures in this section describe how to display the SNMPv3
Tables. The following procedures are provided:
❑ Displaying the Display SNMPv3 User Table Menu on page 319
❑ Displaying the Display SNMPv3 View Table Menu on page 321
❑ Displaying the Display SNMPv3 Access Table Menu on page 322
❑ Displaying the Display SNMPv3 SecurityToGroup Table Menu on
page 323
❑ Displaying the Display SNMPv3 Notify Table Menu on page 324
❑ Displaying the Display SNMPv3 Target Address Table Menu on
page 325
❑ Displaying the Display SNMPv3 Target Parameters Table Menu on
page 326
❑ Displaying the Display SNMPv3 Community Table Menu on page
327
Displaying the
Display SNMPv3
User Table
Menu
This section describes how to display the Display SNMPv3 User Table
Menu. For information about the SNMPv3 User Table, see Creating an
SNMPv3 User Table Entry on page 234.
To display the Display SNMPv3 User Table Menu, perform the following
procedure.
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 59.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16 on page 85.
3. From the SNMP Configuration menu, type 5 to select Configure
SNMPv3 Table.
The Configure SNMP Menu is shown in Figure 71 on page 235.
4. From the Configure SNMP Menu, type 6 to select Display SNMPv3
Table.