Allied Telesis AT-S62 - Manual (Page 681)

AT-S62 User’s Guide
Section VIII: Web Browser Management 681
The SNMP Tab is shown in Figure 232.
Figure 232 Configuration System Page, SNMP Tab
3. To enable SNMP Access, click the box next to Enable SNMP Access.
Use this parameter to enable the switch to be remotely managed
with an SNMP application program.
Note
If the check box in the Enable SNMP Access box is empty, the switch
cannot be managed through SNMP. This is the default.
4. To enable authentication failure traps to be sent on behalf of the
switch, click the box next to Enable Authentication Failure Trap.