Allied Telesis AT-S62 - Manual (Page 752)

Chapter 45: STP, RSTP, and MSTP
Section VIII: Web Browser Management 752
Configuring MSTP
This section is divided into the following procedures:
❑ Configuring MSTP and CIST Parameters on page 752
❑ Associating VLANs to MSTIs on page 755
❑ Configuring MSTP Port Parameters on page 758
This procedure assumes that you have already designated MSTP as the
active spanning tree on the switch. For instructions, refer to Enabling or
Disabling Spanning Tree on page 743.
Configuring
MSTP and CIST
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the Spanning Tree tab.
The Spanning Tree Web Page appears as shown in Figure 265 on
page 743.
4. Click Configure.