Allied Telesis AT-S62 - Manual (Page 376)

Chapter 19: Multiple Spanning Tree Protocol
Section IV: Spanning Tree Protocols 376
3. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
MSTI ID
To change the MSTI priority value for an MSTI, do the following:
1. From the MSTI Menu, type 3 to select MSTI Configuration Menu.
The following prompt is displayed:
Enter the MSTI ID to be modified: [1 to 15] ->
2. Enter the MSTP IDs that you want to modify. The range is 1 to 15. You
can specify only one MSTI ID at a time.
The following prompt is displayed:
Enter new priority [the value will be multiplied by
4096] [0 to 15] -> 8
3. Enter a new MSTI priority number for this MSTI on the bridge. This
parameter is used in selecting a regional root for the MSTI. The range
is 0 (zero) to 61,440 in increments of 4,096, with 0 being the highest
priority. This parameter is used in selecting a regional root for the
MSTI. For a list of the increments, refer to Table 12, Bridge Priority
Value Increments on page 331.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.