Allied Telesis AT-S62 - Manual (Page 721)

AT-S62 User’s Guide
Section VIII: Web Browser Management 721
4. To create an SNMPv3 Target Parameters Table entry, click Add.
The Add New SNMPv3 Target Parameter Table Page is shown in
Figure 252.
Figure 252 Add New SNMPv3 Target Parameters Table Page
5. In the Target Parameters Name field, enter a name of the SNMP
manager or host.
Enter a value of up to 32 alphanumeric characters.
Note
Enter a value for the Message Processing Model parameter only if
you select SNMPv1 or SNMPv2c as the Security Model. If you select
the SNMPv3 protocol as the Security Model, then the Message
Processing Model is automatically assigned to SNMPv3.
6. In the Message Processing Model field, enter an SNMP Protocol that is
used to process messages.
Select one of the following SNMP protocols:
v1
Select this value to process messages with the SNMPv1 protocol.
v2c
Select this value to process messages with the SNMPv2c protocol.
v3
Select this value to process messages with the SNMPv3 protocol.