Allied Telesis AT-S62 - Manual (Page 341)

AT-S62 User’s Guide
Section IV: Spanning Tree Protocols 341
4. If you selected STP as the active spanning tree protocol, go to
Configuring STP on page 342 for further instructions. If you selected
RSTP, go to Configuring RSTP on page 347. If you selected MSTP, go
to Chapter 19 on page 352.
Note
Once you have configured the spanning tree parameters, perform
Steps 5 through 7 to enable spanning tree.
5. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
The following prompt is displayed:
Enter new value (E-Enable, D-Disable):
6. Type E to enable spanning tree or D to disable it. The default is
disabled.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.