Allied Telesis AT-S62 - Manual (Page 131)

AT-S62 User’s Guide
Section I: Basic Operations 131
6. To set the load distribution method, type 3 to toggle the selection
through the following possible settings:
❑ SRC MAC - Source MAC address
❑ DST MAC - Destination MAC address
❑ SRC/DST MAC - Source address /destination MAC address
❑ SRC IP - Source IP address trunking
❑ DST IP - Destination IP address trunking
❑ SRC/DST IP - Source address /destination IP address
The default is SRC/DST MAC. For background information, refer to
Load Distribution Methods on page 123.
7. Type 4 to select Trunk Ports and, when prompted, enter the ports of
the trunk. A trunk can contain up to eight ports. You can identify the
ports individually (for example, 3,7,10), as a range (for example, 5-11),
or both (for example, 2,4,11-14).
8. Type C to select Create Trunk.
The port trunk is now active on the switch.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
10. Configure the ports on the remote switch for port trunking.
11. Connect the cables to the ports of the trunk on the switch.
The port trunk is ready for network operations.