Allied Telesis AT-S62 - Manual (Page 268)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 268
Configuring the SNMPv3 SecurityToGroup Table
This section contains a description of the SNMPv3 SecurityToGroup
Table and how to create, delete, and modify table entries. The SNMPv3
SecurityToGroup Table allows you to associate a User Name with a
Group Name. The User Name is configured in the Configure SNMPv3
User Table Menu while the Group Name is configured in the Configure
SNMPv3 Access Table Menu. In addition, the configuration in the
Configure SNMPv3 Access Table Menu defines which MIB views this User
can read, write (modify), and send traps from. For each User Name, you
can assign:
❑ A Security Model (SNMPv1, SNMPv2c, SNMPv3)
❑ A Group Name
❑ A Storage Type
There are three functions you can perform with the SNMPv3 Access
Table.
❑ Creating an SNMPv3 SecurityToGroup Table Entry on page 268
❑ Deleting an SNMPv3 SecurityToGroup Table Entry on page 271
❑ Modifying an SNMPv3 SecurityToGroup Table Entry on page 272
Creating an
SNMPv3
SecurityToGroup
Table Entry
To create an entry in the SecurityToGroup Table, perform the following
procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 5 to select Configure
SNMPv3 SecurityToGroup Table.