Allied Telesis AT-S62 - Manual (Page 369)

AT-S62 User’s Guide
Section IV: Spanning Tree Protocols 369
Configuring MSTP Bridge Settings
This section contains the procedure for configuring a bridge’s MSTP
settings.
Note
You cannot configure the MSTP parameters until you have selected
the protocol as the active spanning tree protocol on the switch. For
instructions, refer to Enabling or Disabling a Spanning Tree Protocol
on page 340.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 101 on page 340.
2. From the Spanning Tree Menu, type 3 to select Configure Active
Protocol.
The MSTP Menu is shown in Figure 116.
Figure 116 MSTP Menu
Menu selections 1 to 8 are described below. Selections C, M, V, and
P are described in later sections in this chapter.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
MSTP Menu
1 - Force Version .......... MSTP
2 - Hello Time ............. 2
3 - Forwarding Delay ....... 15
4 - Max Age ................ 20
5 - Max Hops ............... 20
6 - Configuration Name .....
7 - Revision Level ......... 0
8 - Bridge Identifier ...... 00:30:24:1E:EE:11
C - CIST Menu
M - MSTI Menu
V - VLAN-MSTI Association Menu
P - MSTP Port Parameters
D - Reset MSTP to Defaults
R - Return to Previous Menu
Enter your selection?