Allied Telesis AT-S62 - Manual (Page 209)

AT-S62 User’s Guide
Section II: Advanced Operations 209
Displaying a List of Host Nodes
You can use the AT-S62 software to display a list of the multicast groups
on a switch, as well as the host nodes. To display the list, perform the
following procedure:
1. From the Main Menu, type 6 to select Advanced Configuration.
The Advanced Configuration menu is shown in Figure 61 on page
206.
2. From the Advanced Configuration menu, type 1 to select IGMP
Snooping Configuration.
The IGMP Snooping Configuration menu is shown in Figure 62 on
page 206.
3. From the IGMP Snooping Configuration menu, type 6 to select View
Multicast Host List.
The View Multicast Host List is shown in Figure 63.
Figure 63 View Multicast Hosts List Menu
The information in this menu is for viewing purposes only. The
columns are defined below:
Multicast Group - The multicast address of the group.
VLAN ID - The VID of the VLAN in which the port is an untagged
member.
Member Port/TrunkID - The port on the switch to which a host node
of the multicast group is connected. If the host node is connected to
the switch through a trunk, the trunk ID number, not the port
number, is displayed.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
View Multicast Hosts List
Number of Multicast Groups: 0
MulticastGroup VLAN ID
Member Port/TrunkIDHostIP Status
------------------------------------------------------------
U - Update Display
R - Return to Previous Menu
Enter your selection?