Allied Telesis AT-S62 - Manual (Page 246)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 246
The following prompt is displayed:
Enter Subtree Mask (Hex format):
6. Enter a subtree mask.
This is an optional parameter that is used to further refine the
value in the View Subtree parameter. This parameter is in binary
format.
The View Subtree parameter defines a MIB View and the Subtree
Mask further restricts a user’s view, for example, to a specific row
of the MIB tree. The value of the Subnet Mask parameter is
dependent on the subtree you select. See RFC 2575 for detailed
information about defining a subnet mask.
The following prompt is displayed:
Enter View Type [I-Included, E-Excluded]:
7. Enter one of the following view types:
I - Included
Enter this value to permit the View Name to see the subtree
specified above.
E - Excluded
Enter this value to not permit the View Name to see the subtree
specified above.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
8. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 View Table to the configuration file. After
making changes to an SNMPv3 View Table entry with a Volatile
storage type, the S - Save Configuration Changes option does not
appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 View Table to the configuration file. After making
changes to an SNMPv3 View Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes.
Note
The Row Status parameter is a read-only field in the Telnet and Local
interfaces. The Active value indicates the SNMPv3 View Table entry
takes effect immediately.