Allied Telesis AT-S62 - Manual (Page 648)

Chapter 39: File Downloads and Uploads
Section VIII: Web Browser Management 648
Uploading a File
This procedure explains how to upload a file from the switch’s file
system to a TFTP server on your network using the web browser
interface. You can upload any of the following files:
❑ Boot configuration file
❑ Public encryption key
❑ CA certificate
❑ CA enrollment request
Note
The public key, CA certificate, and CA enrollment request are only
supported on the version of AT-S62 management software that
features SSL, PKI, and SSH security.
Note the following before you begin this procedure:
❑ You must use TFTP to upload a file using a web browser
management session.
❑ There must be a node on your network that contains the TFTP
server software.
❑ You should start the TFTP server before you begin the upload
procedure.
❑ The switch from which you are uploading a file must have an IP
address and subnet mask, such as a master switch of an enhanced
stack. You cannot use TFTP on a slave switch, since that type of
switch typically does not have an IP address. Rather, you would
need to perform the upload from a local management session of
the switch using Xmodem. For instructions, refer to Chapter 12,
File Downloads and Uploads on page 160.
To upload a file, perform the following procedure:
1. From the Home Page, select Configuration.
The System page is displayed with the General tab selected by
default.
2. Select the System Utilities tab.
The System Utilities tab is shown in Figure 218 on page 646.