Allied Telesis AT-S62 - Manual (Page 708)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 708
Configuring the SNMPv3 Notify Table
You can create, delete, and modify an SNMPv3 Notify Table entry. See
the following procedures:
❑ Creating a Notify Table Entry on page 708
❑ Deleting a Notify Table Entry on page 710
❑ Modifying a Notify Table Entry on page 711
For reference information about the SNMPv3 Notify Table, see
Configuring the SNMPv3 Notify Table on page 708.
Creating a
Notify Table
Entry
To create an entry in the SNMPv3 Notify Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Notify Table. Then click Configure at the bottom of the page.
The SNMPv3 Notify Table Page is shown in Figure 245.
Figure 245 SNMPv3 Notify Table Page