Allied Telesis AT-S62 - Manual (Page 653)

AT-S62 User’s Guide
Section VIII: Web Browser Management 653
Displaying Events
To view the event log, do the following:
1. From the Home Page, click either Configuration or Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586.
2. From the System page, select the Event Log tab.
The Event Log tab is shown in Figure 219 on page 651.
3. Configure the following options:
Severity Selections
Displays events of a selected severity. Choices are I-Informational,
E-Error, W-Warning, D-Debug, and ALL for All. The default is
informational, error, and warning. You can display more than one
severity at a time by holding down the Shift key when making a
selection.
Display Order
Controls the order of the events in the log. Choices are
Chronological, which displays the events in the order oldest to
newest, and Reverse Chronological, which displays the events
newest to oldest. The default is Chronological.
Mode
Controls the format of the event log. Choices are Normal, which
displays the time, module, severity, and description for each
event, and Full, which displays the same information as Normal,
plus filename, line number, and event ID. The default is Normal.
Module Selections
Displays events of a selected AT-S62 module. For a list of the
modules, refer to Modules on page 187. The default is ALL, which
displays the events for all modules. You can display more than
one module at a time by holding down the Shift key when making
a selection.
4. Once you have set the log filters, click View.