Allied Telesis AT-S62 - Manual (Page 314)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 314
Modifying an
SNMPv3
Community
Table Entry
For each entry in the SNMPv3 Community Table, you can modify the
following parameters:
❑ Community Name
❑ Security Name
❑ Transport Tag
❑ Storage Type
However, you cannot modify the Community Index parameter.
Although you can display the SNMPv1 and SNMPv2c configuration
created with the procedures described in Chapter 5: SNMPv1 and
SNMPv2c Configuration on page 81, you cannot modify these
Community Table entries with the SNMPv3 Tables.
See the following procedures:
❑ Modifying the Community Name on page 314
❑ Modifying the Security Name on page 316
❑ Modifying the Transport Tag on page 316
❑ Modifying the Storage Type on page 317
Modifying the Community Name
To modify the Community Name parameter in an SNMPv3 Community
Table entry, perform the following procedure:
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in
Figure 86 on page 311.
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.