Allied Telesis AT-S62 - Manual (Page 594)

Chapter 33: Basic Switch Parameters
Section VIII: Web Browser Management 594
Rebooting a Switch
Note
Any parameters changes that have not been saved will be discarded
when a system is reset. To save parameter changes, refer to Saving
Your Parameter Changes on page 577.
To reboot a switch, perform the following procedure:
1. From the Home Page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586.
2. Click Reset.
A confirmation prompt is displayed.
3. Click OK to reset the switch or Cancel to cancel the procedure.
Note
The switch does not forward packets while it initializes the AT-S62
management software, a process that takes approximately 20
seconds to complete.
Resetting the switch ends your web browser management
session. You must restart the session to continue managing the
switch.