Allied Telesis AT-S62 - Manual (Page 150)

Chapter 11: File System
Section II: Advanced Operations 150
Phase 1: Creating a Configuration File
Before you begin to configure the switch with the parameter settings
that you want to save in a new configuration file, you should first create
the file. Configuring the parameters first and then creating the new
configuration file might cause you to inadvertently change a
configuration file you might not want to change.
To perform this phase, do the following:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 9 to select System
Utilities.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 41.
Figure 41 File Operations Menu
Option 1 - Boot Configuration File specifies the file that is updated
whenever you save a configuration change using the Save
Configuration Changes option in the Main Menu or the Save
Configuration command in the command line interface. It is also
the boot file that the switch will use the next time you reset or
power cycle the unit. Option 2 - Current Configuration specifies
the boot configuration file the switch used the last time it was
reset or power cycled.
4. Type 3 to select Create Configuration File.
Allied Telesyn AT-8524M Series - ATS62
Production Switch
User: Manager 11:20:02 02-Jan-2004
File Operations
1 - Boot Configuration File ............ boot.cfg (Exists)
2 - Current Configuration .............. boot.cfg
3 - Create Configuration File
4 - Copy File
5 - Rename File
6 - Delete File
7 - View File
8 - List Files
R - Return to Previous Menu
Enter your selection?