Allied Telesis AT-S62 - Manual (Page 473)

AT-S62 User’s Guide
Section VI: Port Security 473
Enabling and Disabling Port-based Access Control
This procedure explains how to enable and disable port-based access
control on the switch. If you have not assigned port roles and configured
the parameter settings, you should skip this procedure and go first to
Setting Port Roles on page 474.
To enable or disable Port-based Access Control, perform the following
procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 55 on page 196.
2. From the Security and Services menu, type 1 to select Port Access
Control (802.1X).
The Port Access Control (802.1X) menu is shown in Figure 156.
Figure 156 Port Access Control (802.1X) Menu
Note
Option 2 - Authentication Method cannot be changed.
3. Type 1 to select Port Access Control. The following prompt is
displayed:
Port Access Control (E-Enable, D-Disable):
4. Type E to enable port access control, or D to disable port access
control. Press Return.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Port Access Control (802.1X)
1 - Port Access Control .............. Disabled
2 - Authentication Method ............ RADIUS EAP
3 - Configure Port Access Role
4 - Configure Authenticator
5 - Configure Supplicant
6 - Display Port Access Status
7 - Configure Accounting
R - Return to Previous Menu
Enter your selection?