Allied Telesis AT-S62 - Manual (Page 720)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 720
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
❑ Creating a Target Address Table Entry on page 713
❑ Deleting a Target Address Table Entry on page 716
❑ Modifying Target Address Table Entry on page 717
For reference information about the SNMPv3 Target Parameters Table,
see Configuring the SNMPv3 Target Parameters Table on page 720.
Creating a
Target
Parameters
Table Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 251.
Figure 251 SNMPv3 Target Parameters Table Page