Allied Telesis AT-S62 - Manual (Page 601)

AT-S62 User’s Guide
Section VIII: Web Browser Management 601
Creating a New SNMPv1 or SNMPv2c Community String
To create a new SNMPv1 or SNMPv2c community string, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 198 on page 599.
3. Click Configure in the SNMPv1/v2c section of the tab.
The SNMP tab for SNMPv1 and SNMPv2c community strings is
shown in Figure 199.
Figure 199 SNMP (SNMPv1 and SNMPv2c) Tab
The community strings already existing on the switch are
displayed in the table. The columns are defined below:
Community Name
The name of a community string.
Access Mode
Whether the string’s access is read/write or read only.
Manager Stations
The IP addresses of management stations that can use the
community string to access the switch. This only applies if the
string has a closed access status.
Trap Receivers
The IP addresses of management stations to receive SNMP traps
from the switch.