Allied Telesis AT-S62 - Manual (Page 560)

Chapter 29: RADIUS and TACACS+ Authentication Protocols
Section VII: Management Security 560
f. After making changes, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
7. To configure the RADIUS protocol, from the Authentication Menu in
Figure 181 on page 557 do the following:
a. Type 4 to select RADIUS Configuration.
The RADIUS Client Configuration menu is shown in Figure
183.
Figure 183 RADIUS Client Configuration
b. Configure the parameters as needed. The parameters are defined
below:
Global Encryption Key
This parameter specifies the encryption key for the RADIUS
servers. This option is useful if you will be entering more than
one RADIUS server and all the servers share the same
encryption key. The default is ATI.
Global Server Timeout period
This parameter specifies the maximum amount of time the
switch will wait for a response from a RADIUS server before
assuming that the server will not respond. If the timeout
expires and the server has not responded, the switch queries
the next RADIUS server in the list. If there are not any more
servers, than the switch will default to the standard Manager
and Operator accounts. The default is 30 seconds. The range is
1 to 60 seconds.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Server
User: Manager 11:20:02 02-Jan-2004
RADIUS Client Configuration
1 - Global Encryption Key ............. ATI
2 - Global Server Timeout period....... 30 second(s)
3 - RADIUS Server 1 Configuration ..... 0.0.0.0
4 - RADIUS Server 2 Configuration ..... 0.0.0.0
5 - RADIUS Server 3 Configuration ..... 0.0.0.0
6 - Show Status
R - Return to Previous Menu
Enter your selection?