Allied Telesis AT-S62 - Manual (Page 626)

Chapter 36:MAC Address Table
Section VIII: Web Browser Management 626
Deleting Unicast and Multicast MAC Addresses
To delete a static or dynamic unicast or multicast MAC address from the
switch, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586.
2. From the Configuration menu, select Layer 2.
The Layer 2 page opens with the MAC Address tab selected by
default, as shown in Figure 208 on page 622.
3. Display the MAC addresses on the switch by selecting one of the
options. For instructions, refer to Displaying the MAC Address Table
on page 622.
4. Click on the button next to the MAC address that you want to delete
from the switch.
5. Click Remove.
Note
You cannot delete the switch’s MAC (CPU) address, an STP BPDU
MAC address, or a broadcast address.
6. To permanently save the change, use the Save Changes button in the
General tab. For directions, refer to Saving Your Parameter Changes
on page 577.