Allied Telesis AT-S62 - Manual (Page 342)

Chapter 18: STP and RSTP
Section IV: Spanning Tree Protocols 342
Configuring STP
This section contains the following procedures:
❑ Configuring STP Bridge Settings, next
❑ Configuring STP Port Settings on page 344
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, do the following:
1. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The STP Menu is shown in Figure 102.
Figure 102 STP Menu
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
STP Menu
1 - Bridge Priority ..... 32768
2 - Bridge Hello Time ... 2
3 - Bridge Forwarding ... 15
4 - Bridge Max Age ...... 20
5 - Bridge Identifier ... 00:30:84:00:00:00
P - STP Port Settings
D - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?