Allied Telesis AT-S62 - Manual (Page 557)

AT-S62 User’s Guide
Section VII: Management Security 557
Configuring Authentication Protocol Settings
To configure the RADIUS or TACACS+ settings on the switch, perform
the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 59.
2. From the System Administration menu, type 6 to select
Authentication Configuration.
The Authentication Menu is shown in Figure 181.
Figure 181 Authentication Menu
Note
Option 1 - Server-based Authentication applies only to the manager
account feature described in this chapter. This menu selection has
no affect on the 802.1x port-based access control feature described
in Chapter 24 on page 463.
3. To select the active authentication protocol, type 2 to select
Authentication Method. The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
4. Type T to select TACACS+ or R for RADIUS. The default is TACACS+.
Only one protocol can be active on the switch at a time.
Note
If you selected TACACS+, go to Step 7. If you selected RADIUS, go to
Step 8.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Authentication Menu
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?