Allied Telesis AT-S62 - Manual (Page 713)

AT-S62 User’s Guide
Section VIII: Web Browser Management 713
Configuring the SNMPv3 Target Address Table
You can create, delete, and modify an SNMPv3 Target Address Table
entry. See the following procedures:
❑ Creating a Target Address Table Entry on page 713
❑ Deleting a Target Address Table Entry on page 716
❑ Modifying Target Address Table Entry on page 717
For reference information about the SNMPv3 Target Address Table, see
Configuring the SNMPv3 Target Address Table on page 713.
Creating a
Target Address
Table Entry
To create an entry in the SNMPv3 Target Address Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the
page.