Allied Telesis AT-S62 - Manual (Page 435)

AT-S62 User’s Guide
Section V: Virtual LANs 435
Converting a Dynamic GVRP VLAN
This procedure converts a dynamic GVRP VLAN into a static VLAN. You
can perform this procedure to permanently retain the VLANs the switch
learned through GVRP.
Note
This procedure cannot convert a dynamic GVRP port in a static VLAN
into a static port. For that you must manually modify the static VLAN,
specifying the dynamic port as either a tagged or untagged
member of the VLAN.
To convert a dynamic GVRP VLAN to a static VLAN, perform the following
procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 125 on page 400.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 126 on page 401.
Note
If option “4 - Configure VLANs” is not displayed in the menu, the
switch is running a multiple VLAN mode. To change a switch’s VLAN
mode, refer to Selecting a VLAN Mode on page 451.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 128 on page 406.
4. Type 2 to select Change GARP VLAN.
The following prompt is displayed:
Enter VLAN ID: [1 to 4096] ->
5. Enter the VID of the dynamic GVRP VLAN you want to convert into a
static VLAN. You can specify only one VLAN at a time.
The dynamic GVRP VLAN is changed to a static VLAN. To confirm
this, refer to Displaying VLANs on page 410.
6. Return to the Main Menu and type S to select Save Configuration
Changes.