Allied Telesis AT-S62 - Manual (Page 652)

Chapter 40: Event Log
Section VIII: Web Browser Management 652
3. For Status in Log Settings, click either Disable or Enable. If you
enable the log, the system immediately begins to add events to the
log. The default is enabled.
4. For Log Full Action, click either Wrap or Halt. The Wrap option causes
the log to delete old entries as it adds new entries once it reaches its
maximum capacity of 4,000 events. The Halt option causes the log to
stop adding new entries once it reaches maximum capacity. The
default is Wrap.
5. Click Apply.
6. To permanently save the change, use the Save Changes button in the
General tab. For directions, refer to Saving Your Parameter Changes
on page 577.
To display the events in the log, go to the next procedure.