Allied Telesis AT-S62 - Manual (Page 476)

Chapter 24: 802.1x Port-based Access Control
Section VI: Port Security 476
Configuring Authenticator Port Parameters
Note
A port must be set to the authenticator role before you can
configure its settings. For instructions on how to set a port’s role,
refer to Setting Port Roles on page 474.
To configure authenticator port parameters, perform the following
procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 55 on page 196.
2. From the Security and Services menu, type 1 to select Port Access
Control (802.1X).
The Port Access Control (802.1X) menu is shown in Figure 156 on
page 473.
3. In the Port Access Control (802.1X) menu, type 4 to select Configure
Authenticator.
The Configure Authenticator menu is shown in Figure 158.
Figure 158 Configure Authenticator Menu
4. Type 1 to select Configure Authenticator Port Access Parameters.
The following prompt is displayed:
Enter port list ->
5. Enter the authenticator port number whose parameters you want to
change. You can specify one port or a range of ports (for example, 4-
8), but not nonconsecutive ports (for example, 4,6,11).
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Configure Authenticator
1 - Configure Authenticator Port Access Parameters
2 - Display Authenticator Port Access Parameters
R - Return to Previous Menu
Enter your selection?