Allied Telesis AT-S62 - Manual (Page 778)

Chapter 47: GARP VLAN Registration Protocol
Section VIII: Web Browser Management 778
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This will
protect against unauthorized access to restricted areas of your
network. For further information, refer to GVRP and Network
Security on page 424.
1. From the Home Page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586
2. From the Configuration menu, select the Layer 2 option.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 278 on page 776.
4. Click a port in the graphical image of the switch.
5. Click Modify.
The GVRP Port Configuration page is shown in Figure 279.
Figure 279 GVRP Port Configuration Page
6. Change the port mode if desired.
A setting of Normal means the port processes and propagates
GVRP information. This is the default setting. A setting of None
prevents the port from processing GVRP information and from
transmitting PDUs.
7. Click Apply.
A change to GVRP port mode is immediately activated on a port.