Allied Telesis AT-S62 - Manual (Page 282)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 282
Modifying a Storage Type
To modify the Storage Type parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 6 to select Configure
SNMPv3 Notify Table.
The Configure SNMPv3 Notify Table Menu is shown in Figure 80
on page 277.
3. From the Configure SNMPv3 Notify Table Menu, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table is shown in Figure 81 on page
280.
4. To modify the Storage Type, type 3 to select Set Storage Type.
The following prompt is displayed:
Enter Notify Name:
5. Enter a Notify Name.
The following prompt is displayed:
Enter Storage type [V-Volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 Notify Table to the configuration file. After
making changes to an SNMPv3 Notify Table entry with a Volatile
storage type, the S - Save Configuration Changes option does not
appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file. After making
changes to an SNMPv3 Notify Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.